 |
 |
 |
|
| The new NT2-A is a professional large capsule (1 in.) condenser studio microphone with variable pick-up pattern,variable high pass filter and variable pad. These features provide greater creative control and versatility. |
|
|
|
|
|
 |
|
 |
|
Features
- Three 3-position switches located on the mic body provide the freedom to step from Figure 8, Cardioid or Omni polar pick-up patterns; from a flat response to either 80 Hz or 40 Hz high-pass filter and a Pad adjustment of 0 dB, -5 dB or -10 dB attenuation.
- The heart of the NT2-A is the Australian designed and manufactured TYPE HF1 dual diaphragm capsule. The frequency and transient response of this new transducer has been voiced to complement today s modern recording techniques,and yet still evoke the silky smooth character of the legendary microphones of the 50's and 60's.The NT2-A includes a soft pouch and clip.
- Features
- The Australian designed and manufactured HF1 1 edge terminated,gold sputtered, dual 5 um diaphragm capsule.
- 3-position variable polar pattern: Omni, Cardioid &Figure 8; all controlled on the mic.
- 3-position variable high-pass filter: Flat,80 Hz or 40 Hz.
- 3-position variable pad:0 dB,-5 dB or -10 dB.
- Ultra low noise,transformerless SMT circuitry.
- Wide dynamic range.
- High strength heat-treated steel mesh head.
- Durable satin nickel finish.
- Internal capsule shock mounting.
- Supplied complete with soft pouch and clip.
- Technical Info
- Power
- The NT2-A is designed to operate from phantom power to the P48 standard.
- The NT2-A will operate between 44V and 52V applied with positive polarity to pin 2 and pin 3 of the output XLR connector.
- Output Impedance
- The NT2-A will operate satisfactorily into a load impedance as low as 1K. If a load below this is used, the output signal level will be reduced.
- The NT2-A output is balanced between pin 2 (hot) and pin 3 (cold). Pin 1 is ground.
- Specifications
- Acoustic principle: Externally polarized 25 mm (1 in.) dual diaphragm.
- Directional pattern: Multi-pattern
- Frequency range: 20 Hz - 20 000 Hz
- Output impedance: 200
- Signal /Noise ratio DIN/IEC 651: 87 dB (1 kHz rel 1 Paper IEC651, IEC268-15)
- Equivalent noise: 7 dBA SPL (per IEC651, IEC268-15)
- Maximum SPL: 147 dB (@1%THD into 1k) 157 dB (@1%THD into 1k) - pad at maximum
- Sensitivity at 1 kHz into 1k: -36 dB re 1 Volt/Pascal (16 mV @94 dB SPL) +/- 2 dB
- Maximum output voltage: +16 dBu (@1%THD into 1k)
- Dynamic range of the mic amplifier: DIN/IEC 651 140 dB (per IEC651, IEC268-15)
- Power (Supply voltage): 48 Volts (P48)
- Output Connection: 3 pin XLR,balanced output between pin 2 (+) and pin 3 (-). Pin 1 ground
- Weight approx.: 860 grm (4.23 oz)
|
|
|
 |
|
 |
|
|
|
